LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1024 (Drive Axle - Locking/Limited Slip) >> Diagnostic Information and Procedures >> Locking Rear Axle Locks in Turns

Locking Rear Axle Locks in Turns

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Locking Rear Axle Locks in Turns

Checks Action
The governor assembly is tight in the case Free up the governor assembly. Refer to Locking Differential Disassemble (8.6, 9.5, 11.5 Inch Axle)  or Locking Differential Disassemble (10.5 Inch Axle)  and Locking Differential Assemble (8.6, 9.5, 11.5 Inch Axles)  or Locking Differential Assemble (10.5 Inch Axle) .
Broken or weak governor flyweight spring Replace the governor assembly and the latching bracket. Refer to Locking Differential Disassemble (8.6, 9.5, 11.5 Inch Axle)  or Locking Differential Disassemble (10.5 Inch Axle)  and Locking Differential Assemble (8.6, 9.5, 11.5 Inch Axles)  or Locking Differential Assemble (10.5 Inch Axle) .
The flyweight in the governor assembly is stuck open Replace the governor assembly and the latching bracket. Refer to Locking Differential Disassemble (8.6, 9.5, 11.5 Inch Axle)  or Locking Differential Disassemble (10.5 Inch Axle)  and Locking Differential Assemble (8.6, 9.5, 11.5 Inch Axles)  or Locking Differential Assemble (10.5 Inch Axle) .
The cam plate or the governor drive teeth are broken Replace the cam plate, the governor assembly, and the latching bracket. Refer to the following: