LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1023 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement (15/25 Series) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stabilizer shaft insulators.
    2. Fig 1: Installing The Stabilizer Shaft (15/25 Series)
    GM582397Courtesy of GENERAL MOTORS CORP.
  2. Install the stabilizer shaft.
  3. Install the stabilizer shaft insulator brackets to the rear axle.
  4. Install the stabilizer shaft bracket mounting bolts.
    Fig 2: Installing The Stabilizer Shaft Bracket Mounting Bolts (15/25 Series)
    GM613612Courtesy of GENERAL MOTORS CORP.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: When tightening the lower link nut verify that the inner jam nut bottoms out on the ball stud.
  5. Install the stabilizer shaft link nut to the ball stud.

    Tighten: 

    1. Tighten the ball stud to stabilizer shaft nut to 65 N.m (48 lb ft).
    2. Tighten the insulator bracket bolts to 33 N.m (24 lb ft).

  6. Lower the vehicle.
scientia non olet · About LEMON Manuals