LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1020 (Propeller Shaft And Universal Joints) >> Repair Instructions >> Propeller Shaft Center Support Bearing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the propeller shaft. Refer to Propeller Shaft Replacement - Two Piece .
  3. Remove the center bearing by doing the following:
    1. Stand the propeller shaft (2) on end in the press (1) with the center bearing (3) supported by the press bars (4).
    2. Press the propeller shaft (2) down and off the center bearing (3).
      3. Fig 1: Pressing The Propeller Shaft Down And Off The Center Bearing
      GM348612Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals