LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1020 (Propeller Shaft And Universal Joints) >> Diagnostic Information and Procedures >> Knock or Clunk Noise

Knock or Clunk Noise

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Knock or Clunk Noise

Checks Action
DEFINITION: Knocking or clunking noise occurs when operating the vehicle in high gear or coasting in neutral at 16 km/h (10 mph).
One or more of the universal joints are worn or damaged. Replace the universal joint. Refer to the following:
The side gear hub counterbore in the differential is worn oversize. Replace the differential case and/or the side gears. Refer to Differential Replacement (8.6 Inch, 9.5 Inch Axles) , Differential Replacement (9.75 Inch Axle) or Differential Replacement (10.5 Inch, 11.5 Inch Axle) in Rear Drive Axle.