Clearing Transmission Adaptive Pressure

WARNING: This page does not describe the selected car, but rather 36 other vehicles, including the 2002 Pontiac Firebird, 2002 Oldsmobile Bravada, 2002 GMC Yukon XL, 2002 GMC Yukon, and 2002 GMC Sonoma. However, it is still accessible from the selected car via links, so may be relevant.

Transmission Adaptive Pressure (TAP) information is displayed and may be reset using a scan tool.

The adapt function is a feature of the PCM that either adds or subtracts line pressure from a calibrated base line pressure in order to compensate for normal transmission wear. The TAP information is divided into 13 units called cells. The cells are numbered 4 through 16. Each cell represents a given torque range. TAP cell 4 is the lowest adaptable torque range and TAP cell 16 is the highest adaptable torque range. It is normal for TAP cell values to display zero or negative numbers. This indicates that the PCM has adjusted line pressure at or below the calibrated base line pressure.

Updating TAP information is a learning function of the PCM designed to maintain acceptable shift times. It is not recommended that TAP information be reset unless one of the following repairs has been made: Transmission overhaul or replacement. Repair or replacement of an apply or release component (clutch, band, piston, servo). Repair or replacement of a component or assembly which directly affects line pressure.

Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, the PCM will need to relearn TAP values. Transmission performance may be affected as new TAPs are learned. Learning can only take place when the PCM has determined that an acceptable shift has occurred. The PCM must also relearn TAP values if it is replaced.