New Special Tools Required
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Angle Meter J 45059 has been developed to provide technicians with a convenient method to tighten bolts that require the torque angle tightening strategy.
- J 41479-2A has been developed to install the rear oil seal on RPO HP2 equipped vehicles.
- J 45849 has been developed to remove the pilot bushing on RPO HP2 equipped vehicles when the crankshaft is replaced.
- J 45949 has been developed to install the pilot bushing on RPO HP2 equipped vehicles when the crankshaft has been replaced.
- J 46093 has been developed to hold the cranktrain stationary on RPO HP2 equipped vehicles to allow for the on-vehicle removal and installation of the crankshaft balancer.
- Refer to Special Tools and Equipment .