LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1011 (Disc Brake System) >> Repair Instructions >> Brake Rotor Replacement - Rear (W/Dual Wheels) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the park brake.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  4. Remove the hub and rotor assembly. Refer to Rear Axle Hub, Bearing, Cup, and/or Seal Replacement in Rear Drive Axle.
  5. Mark the relationship of the hub to the rotor.
  6. Place the hub and rotor assembly on a hydraulic press.
  7. Press the wheel studs out of the hub and rotor assembly.
    8. Fig 1: Wheel Studs, Hub & Rotor Assembly - Rear (W/Dual Wheels)
    GM892159Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals