LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1006 (Seat Belt System) >> Repair Instructions >> Seat Belt Replacement - Center Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the bolt (1) to the seat belt anchor.

    Tighten:  Tighten the bolt to 52 N.m (38 lb ft).

    Fig 1: Installing The Bolt In Seat Belt Anchor - Center Rear
    GM811814Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    2. Fig 2: Installing The Nut To The Seat Belt Retractor - Center Rear
    GM811807Courtesy of GENERAL MOTORS CORP.
  2. Install the nut to the seat belt retractor.

    Tighten:  Tighten the nut to 52 N.m (38 lb ft).

  3. Install the J-Clip under the center armrest.
  4. Install the rear seat armrest. Refer toArmrest Replacement - Rear Seat (60/40 Split) in Seats.
  5. Install the seat belt guide cover (1).
    Fig 3: Installing The Seat Belt Guide Cover - Center Rear
    GM811802Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals