LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1003 (Automatic Transmission - 4L60-E/4L65-E (Troubleshooting)) >> Troubleshooting >> Road Test Procedure (M30/M32) >> Manual Downshifts

Manual Downshifts

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

The shift solenoid valves do not control the initial downshift for the 4-3 or the 3-2 manual downshifts. The 4-3 and the 3-2 manual downshifts are hydraulic. The 2-1 manual downshift is electronic. The solenoid states should change during or shortly after a manual downshift is selected.

Manual 4-3 Downshift

  1. Place the gear selector in the OVERDRIVE position.
  2. Accelerate the vehicle to 64-88 km/h (40-55 mph) in FOURTH gear.
  3. Release the throttle while moving the gear selector to THIRD.
  4. Verify the following:
    • The TCC releases
    • The transmission downshifts immediately to THIRD gear
    • The engine slows the vehicle

Manual 4-2 Downshift

  1. Place the gear selector in the OVERDRIVE position.
  2. Accelerate the vehicle to 64-72 km/h (40-45 mph).
  3. Release the throttle while moving the gear selector to SECOND.
  4. Verify the following:
    • The TCC releases
    • The transmission downshifts immediately to SECOND gear
    • The engine slows the vehicle

Manual 4-1 Downshift

  1. Place the gear selector in the OVERDRIVE position.
  2. Accelerate the vehicle to 48 km/h (30 mph).
  3. Release the throttle while moving the gear selector to FIRST.
  4. Verify the following:
    • The TCC releases.
    • The transmission downshifts immediately to FIRST gear.
    • The engine slows the vehicle.