Engine Coolant/Water in Transmission
WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The antifreeze or water will deteriorate the seals, gaskets and the glue that bonds the clutch material to the pressure plate. Both conditions may cause damage to the transmission.
If antifreeze or water has entered the transmission, perform the following:
- Disassemble the transmission.
- Replace all of the rubber type seals (the coolant will attack the seal material which will cause leakage).
- Replace the composition-faced clutch plate assemblies (the facing material may separate from the steel center portion).
- Replace all of the nylon parts (washers).
- Replace the torque converter.
- Thoroughly clean and rebuild the transmission, using new gaskets and oil filter.
- Flush the cooler lines after the transmission cooler has been properly repaired or replaced.