LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1002 (Transfer Case - NVG 261-NP2) >> Repair Instructions >> Transfer Case Gear Indicator Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the gear indicator switch.

    Tighten:  Tighten the switch to 27 N.m (20 lb ft).

    2. Fig 1: Installing Transfer Case Gear Indicator Switch
    GM393367Courtesy of GENERAL MOTORS CORP.
  2. Connect the gear indicator switch electrical connector (2).
    3. Fig 2: Connecting Transfer Case Gear Indicator Switch Electrical Connector
    GM860643Courtesy of GENERAL MOTORS CORP.
  3. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
scientia non olet · About LEMON Manuals