LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal & Installation >> Ignition Systems >> Ignition Coil >> Removal

Ignition Coil: Removal

  1. Turn ignition off. Remove engine cover. See ENGINE COVER  under AIR INDUCTION SYSTEMS. Disconnect harness connectors from ignition coil. Slightly twist ignition coil wire at ignition coil. See Fig 1 . Remove ignition coil wire at ignition coil by pulling on the wire boot.
  2. Remove ignition coil mounting studs. See Fig 2 . Remove ignition coil assembly. Drill and punch out the 2 rivets holding the ignition coil to the bracket. See Fig 3 . Remove ignition coil from bracket.
Fig 1: Removing Ignition Coil Wire
G00143828Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing Ignition Coil
G00143829Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing Ignition Coil & Ignition Control Module From Mounting Bracket
G00143830Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals