LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Propeller Shaft And Universal Joints >> Repair Instructions >> Propeller Shaft Replacement - Rear >> Installation Procedure

Installation Procedure

  1. Install the propeller shaft into the transmission.

    Important:  Install a new universal joint whenever a slip joint or companion flange is serviced.

  2. Lubricate the slip joint.
  3. Install the yoke and cross assembly onto the pinion flange.
  4. Align the reference marks on the pinion flange and the propeller shaft rear yoke. Seat the yoke properly.
  5. Install the retainers.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  6. Install the bolts into the pinion flange.

    Tighten 

    Tighten the bolts to 36 N.m (27 lb ft).

    Fig 1: Installing Bolts Into Pinion Flange
    G01642879Courtesy of GENERAL MOTORS CORP.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals