LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Drive Axle >> Repair Instructions >> Rear Axle Shaft Seal and/or Bearing Replacement >> Removal Procedure

Removal Procedure

  1. Raise the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  2. Remove the tire and wheel Assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  3. Remove the rear axle housing cover. Refer to REAR AXLE HOUSING COVER AND GASKET REPLACEMENT .
  4. Remove the axle shaft. Refer to REAR AXLE SHAFT REPLACEMENT .
  5. Remove the axle shaft seal and the bearing from the axle housing using the J 23689  (1) and the J 2619-01  (2).
    Fig 1: Removing Axle Shaft Seal & Bearing From Axle Housing Using J 23689 & J 2619-01
    G01643108Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals