Installation Procedure
- Install the new gasket.
- Install the rear axle cover.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Install the rear axle cover bolts.
Tighten
Tighten the bolts to 30 N.m (22 lb ft) in a crosswise pattern.
- Add axle lubricant to the axle housing. Use the proper fluid. Refer to SPECIFICATIONS in General Information.
- Install the fill plug.
Tighten
Tighten the fill plug to 33 N.m (24 lb ft).
- Lower the vehicle.