Installation Procedure
- Install the new rear axle housing cover gasket and the rear axle housing cover.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Install the rear axle housing cover bolts.
Tighten
Tighten the rear axle housing cover bolts to 30 N.m (22 lb ft).
- Fill the rear axle. Use the proper fluid. Refer to SPECIFICATIONS in General Information.
- Install the rear axle fill plug.
Tighten
Tighten the rear axle fill plug to 33 N.m (24 lb ft).
- Lower the vehicle.