LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Drive Axle - Locking/Limited Slip Rear Axle >> Repair Instructions >> Locking Differential Cam Unit Disassemble

Locking Differential Cam Unit Disassemble

  1. Measure the length of the cam gear with the thrust washer installed. Measure the length from the edge of the gear tooth to the back side of the gear.

    Record the measurement.

  2. Remove the retaining ring using snap ring pliers.
    Fig 1: Removing Retaining Ring Using Snap Ring Pliers
    G01643176Courtesy of GENERAL MOTORS CORP.
  3. Remove the clutch plates.
  4. Remove the guide clips.
  5. Remove the wave washer.
  6. Remove the cam plate.
  7. Remove the side cam gear.
scientia non olet · About LEMON Manuals