LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System >> Repair Instructions >> Seat Back Hinge Trim Replacement - Rear Right (YC6) >> Installation Procedure

Installation Procedure

  1. Install the upper seat back hinge cover:
    1. 1.1. Align the seat back hinge cover fasteners with the hinge.
    2. 1.2. Press the seat back hinge cover into place.
  2. Install the latch lever escutcheon:
    1. 2.1. Pivot the escutcheon so that the escutcheon retaining tabs engage the slots on the upper hinge cover and clear the latch lever.
    2. 2.2. Attach the J-hook fasteners at the escutcheon's inner edge to the carpet on the back of the seat back trim cover.
  3. Install the lower hinge cover:
    1. 3.1. Align the seat back hinge cover fasteners with the hinge.
    2. 3.2. Press the seat back hinge cover into place.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Installing Screw Retaining Lower Seat Back Hinge Cover
    G01567187Courtesy of GENERAL MOTORS CORP.
  4. Install the screw that retains the lower seat back hinge cover.

    Tighten 

    Tighten the lower seat back hinge cover retaining screw to 2 N.m (18 lb in).

  5. Install the rear bench seat to the vehicle. Refer to SEAT REPLACEMENT - REAR BENCH  .
scientia non olet · About LEMON Manuals