LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System >> Repair Instructions >> Seat Back Hinge Trim Replacement - Rear Left >> Installation Procedure

Installation Procedure

  1. Install the upper seat back hinge cover as follows:
    1. 1.1. Align the fasteners with the hinge.
    2. 1.2. Press the lower seat back hinge cover into place.
      Fig 1: Identifying Lower Seat Back Hinge Cover
      G01567184Courtesy of GENERAL MOTORS CORP.
  2. Install the lower seat back hinge cover as follows:
    1. 2.1. Align the fasteners with the hinge.
    2. 2.2. Press the upper seat back hinge cover into place.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the lower seat back hinge cover retaining screw.

    Tighten 

    Tighten the lower seat back hinge cover retaining screw to 2 N.m (18 lb in).

  4. Install the rear bench seat to the vehicle. Refer to SEAT REPLACEMENT - REAR BENCH  .
    Fig 2: Identifying Upper Seat Back Hinge Cover
    G01567185Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals