LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Jimmy 4D Utility, 4WD, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instructions >> Closeout/Insulator Panel Replacement - Instrument Panel (I/P) Lower >> Installation Procedure

Installation Procedure

  1. Connect the electrical connector to the accessory power outlet, if equipped.
  2. Install the instrument panel sound insulator to the vehicle.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the screws that retain the instrument panel sound insulator to the following components:
    • The knee bolster
    • The instrument panel
    • The floor duct

      Tighten 

      Tighten the screws to 1.5 N.m (13 lb in).

  4. Install the screw that retains the instrument panel sound insulator to the heater assembly.

    Tighten 

    Tighten the screw to 1.5 N.m (13 lb in).

  5. Install the center console to the vehicle if equipped with RPO code YC7 (GMC Envoy). Refer to CONSOLE REPLACEMENT - FRONT FLOOR (FULL LENGTH (AUTO TRANS))  or CONSOLE REPLACEMENT - FRONT FLOOR (FULL LENGTH (ENVOY))  or CONSOLE REPLACEMENT - FRONT FLOOR (NON-FULL LENGTH)  or CONSOLE REPLACEMENT - FRONT FLOOR (FULL LENGTH (MANUAL TRANS)) .
    Fig 1: Closeout/Insulator Panel - Instrument Panel Lower
    G01476621Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals