LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Jimmy 2D Utility, Part Time, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Computer Relearn Procedures) >> General Motors (Trucks & Vans) >> Theft Deterrent System Components >> 30-Minute Learn Procedure (Avalanche, Astro, Blazer, Cab & Chassis, Chevy Express, Cutaway, Escalade, Escalade EXT, Jimmy Canadian, RV Cutaway, S10 Pickup, Safari, Savana, Savana Camper Special & Savana Special, Sierra, Silverado, Sonoma, Suburban, Tahoe, Yukon & Yukon XL)

30-Minute Learn Procedure (Avalanche, Astro, Blazer, Cab & Chassis, Chevy Express, Cutaway, Escalade, Escalade EXT, Jimmy Canadian, RV Cutaway, S10 Pickup, Safari, Savana, Savana Camper Special & Savana Special, Sierra, Silverado, Sonoma, Suburban, Tahoe, Yukon & Yukon XL)

WARNING: This page does not describe the selected car, but rather 120 other vehicles, including the 2002 Saturn Vue, 2002 Saturn SL2, 2002 Saturn SL1, 2002 Saturn SL, and 2002 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If replacing the Passlock™ module with a GM Service Parts Operations (SPO) replacement part, the module will learn Passlock™ sensor data code immediately. The existing PCM however, must learn the new fuel continue password when the Passlock™ module is replaced.

If replacing a PCM/ECM with a GM Service Parts Operations (SPO) replacement part, after programming, these modules will learn the incoming fuel continue password immediately upon receipt of a password message. Once a password message is received, and a password is learned, a learn procedure must be performed to change this password again. A PCM which has been previously installed in another vehicle will have learned the other vehicle's fuel continue password and will require a learn procedure after programming to learn the current vehicle's password.

Use this procedure after replacing:

    NOTE: Ensure current Techline® Service Programming System (SPS) software is used.
  1. Turn ignition on, with engine off.
  2. Attempt to start engine, then release key to ON position. Vehicle should not start.
  3. Observe SECURITY indicator light for about 10 minutes. Indicator light should turn off.
  4. Turn ignition off and wait 5 seconds.
  5. Repeat steps  1- 4 two more times for a total of 3 cycles/30 minutes. Vehicle is now ready to relearn the Passlock™ sensor data code and/or passwords on the next ignition switch transition from OFF to CRANK position.
    6. NOTE: Vehicle learns Passlock™ sensor data code and/or password on the next ignition switch transition from OFF to CRANK position. Ignition must be turned off before attempting to start vehicle.
  6. Start engine. Vehicle has now learned the Passlock™ sensor data code and/or password.
  7. Using scan tool, clear any DTCs. History DTCs will self clear after 100 ignition cycles.
scientia non olet · About LEMON Manuals