LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Jimmy 2D Utility, Part Time, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Vacuum Brake Booster >> Installation

Vacuum Brake Booster: Installation

  1. Install the vacuum booster assembly and the gasket. See Fig 1.
  2. Install the vacuum booster mounting nuts on the vacuum booster. Tighten the vacuum booster mounting nuts to specification. See TORQUE SPECIFICATIONS .
  3. Install the steering column support bracket. See appropriate STEERING COLUMN article in STEERING.
  4. Install the stoplight switch and the pushrod to the brake pedal pin.
  5. Install the pushrod retainer to the brake pedal pin. The retainer will snap into place.
  6. Install the left closeout/insulator panel.
  7. Install the check valve to the vacuum booster.
  8. Install the master cylinder. See MASTER CYLINDER .
Fig 1: Removing & Installing Vacuum Brake Booster
G00305464Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals