LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Jimmy 2D Utility, Part Time, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Brake Pads - Rear >> Installation

Brake Pads - Rear: Installation

  1. Install the NEW anti rattle springs on the mounting bracket.
  2. Install the rear brake pads on the mounting bracket. See Fig 1.
  3. Install the anti rattle spring on the rear brake caliper.
  4. Install the brake caliper assembly on the mounting bracket. See BRAKE CALIPER - REAR .
  5. Lower the vehicle.
  6. Fill the brake master cylinder to the proper level. See MASTER CYLINDER RESERVOIR FILLING  under BLEEDING.
  7. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
  8. Slowly release the brake pedal.
  9. Wait 15 seconds, then repeat steps  7 and  8 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
  10. Burnish the new brake pads. See BURNISHING PADS AND ROTORS  under SERVICING.
Fig 1: Removing & Installing Brake Pads (Rear)
G00305461Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals