LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Jimmy 2D Utility, Part Time, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Overhaul >> Brake Caliper - Rear >> Assembly

Brake Caliper - Rear: Assembly

  1. Lubricate the new piston seal, the caliper bore, and the piston with clean brake fluid.
  2. Install the piston seal. Make sure the piston seal is not twisted in the caliper bore groove.
  3. Install the boot into the caliper housing bore by hand.
  4. Install the piston in the caliper bore. Push the piston to the bottom of the bore by hand.
  5. Install the boot on the piston.
Fig 1: Exploded View Of Single Piston Caliper Assembly
G00030580Courtesy of GENERAL MOTORS CORP.
Fig 2: Exploded View Of Dual Piston Caliper Assembly
G00030581Courtesy of GENERAL MOTORS CORP.
Fig 3: Exploded View Of Rear Brake Shoe Assembly
G95H27109Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals