LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Jimmy 2D Utility, Part Time, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Adjustments & Inspection >> Disc Brake System >> Disc Brake Mounting & Hardware Inspection - Rear

Disc Brake Mounting & Hardware Inspection - Rear

  1. With the disc brake caliper removed, inspect the disc brake pad mounting hardware for the following:
    • Missing mounting hardware.
    • Excessive corrosion.
    • Bent mounting tabs.
    • Looseness at the caliper mounting bracket.
    • Looseness at the disc brake pads.
  2. If any of the conditions listed are found, replace the disc brake pad mounting hardware. See DISC BRAKE HARDWARE - REAR  under REMOVAL & INSTALLATION.
  3. With the disc brake pads held firmly in place on the brake caliper mounting bracket, ensure that the pads slide easily on the mounting hardware without binding.
  4. Inspect the brake caliper housing bolts by gently pulling outward, without disengaging the brake caliper housing bolts from the boots, pushing inward, and observe for the following:
    • Binding.
    • Seizing.
    • Looseness in the caliper mounting bracket.
    • Bent or damaged caliper bolts.
    • Missing boots.
    • Bent or damaged caliper mounting bracket.
  5. If any of the conditions listed are found, the brake caliper hardware requires replacement. See DISC BRAKE HARDWARE - FRONT DUAL PISTON  or DISC BRAKE HARDWARE - FRONT SINGLE PISTON  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals