LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Jimmy 2D Utility, Automatic, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel & Steering Column >> Repair Instructions >> Lower Bearing and Steering Column Jacket Replacement (Floor Shift Standard) >> Installation Procedure

Installation Procedure

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Attach the steering column support assembly (2) to the steering column jacket assembly (3) with 4 NEW TORX® head screws (1).

    Tighten 

    1. Tighten the screws to 17 N.m (13 lb ft).
    Fig 1: Installing Steering Column Support Assembly To Steering Column Jacket Assembly
    G01467555Courtesy of GENERAL MOTORS CORP.
  2. Install the steering shaft assembly (1) into the support assembly (2) and the jacket assembly (3).
    Fig 2: Installing Steering Shaft Assembly Into Support Assembly & Jacket Assembly
    G01467556Courtesy of GENERAL MOTORS CORP.
  3. Install the adapter and bearing assembly (1) onto the jacket assembly by performing the following procedure:
    1. 3.1. Align the tab on the adapter and bearing assembly (1) with the slot in the steering column jacket assembly.
    2. 3.2. Push the adapter and bearing assembly (1) onto the steering shaft assembly until the tab snaps into the slot.
  4. Install the shaft seal retainer (2) onto the adapter and bearing assembly (1):
    1. 4.1. Align the slots of the shaft seal retainer (2) to the ribs of the adapter and bearing assembly (1).
    2. 4.2. Push the shaft seal retainer (2) onto the steering shaft assembly.
  5. Install the steering shaft seal (3) onto the steering shaft assembly.
  6. Install the inner boot seal (4) onto the steering shaft assembly.
    Fig 3: Installing Adapter & Bearing Assembly Onto Jacket Assembly
    G01467557Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR INFLATOR MODULE COIL CAUTION in Cautions and Notices.

    Important: The electrical contact of the turn signal and multifunction switch assembly must rest on the turn signal cancel cam assembly.

  7. Install the turn signal and multifunction switch assembly (2) onto the steering column housing assembly.
  8. Screw the 2 pan head tapping screws (1) into the turn signal and multifunction switch assembly (2).

    Tighten 

    1. Tighten the screws to 7 N.m (62 lb in).
  9. Install the ignition lock cylinder case. Refer to IGNITION LOCK CYLINDER CASE REPLACEMENT (FLOOR SHIFT)  or IGNITION LOCK CYLINDER CASE REPLACEMENT (COLUMN SHIFT) .
  10. Install the ignition lock cylinder. Refer to IGNITION LOCK CYLINDER REPLACEMENT .
  11. Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM in SIR.
Fig 4: Installing Turn Signal & Multifunction Switch Assembly Onto Steering Column Housing Assembly
G01467558Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals