Brake Hoses: Installation
NOTE:
DO NOT reuse the old metal/copper, gaskets. Use only NEW metal/copper, gaskets.
- Install the NEW metal/copper gaskets to the brake hose and bolt.
- Install the brake hose bolt to the brake caliper.
- Install the brake hose to brake caliper. Tighten the brake hose bolt. See TORQUE SPECIFICATIONS .
- Install the brake hose retaining bolt to the frame. Tighten the brake hose bolt. See TORQUE SPECIFICATIONS .
- Remove the rubber cap or plug from the brake pipe fitting.
- Install the brake pipe to the brake hose. Tighten the brake pipe fitting. See TORQUE SPECIFICATIONS
- Fill the brake master cylinder reservoir. See MASTER CYLINDER RESERVOIR FILLING under BLEEDING, FILLING & FLUSHING BRAKE SYSTEM.
- Bleed the hydraulic brake system. See MANUAL BLEEDING under BLEEDING, FILLING & FLUSHING BRAKE SYSTEM.
- Install the tire and wheel assembly. Tighten to specification. See TORQUE SPECIFICATIONS . Lower the vehicle.
NOTE:
DO NOT reuse the old metal/copper gaskets. Use only NEW metal, copper, gaskets.
- Install the NEW metal/copper gaskets to the rear brake caliper bolt.
- Install the rear brake hose to the rear brake caliper. Tighten the rear brake bolt. See TORQUE SPECIFICATIONS .
- Remove the rubber plug and/or cap from the rear brake pipe fitting.
- Install the brake pipe to the brake hose.
- Using a backup wrench, install the rear brake pipe to the brake hose. Tighten the rear brake pipe fitting. See TORQUE SPECIFICATIONS .
- Install the brake pipe retaining bolt at the frame. Tighten the brake pipe retaining bolt. See TORQUE SPECIFICATIONS
- Bleed the hydraulic brake system. See MANUAL BLEEDING under BLEEDING, FILLING & FLUSHING BRAKE SYSTEM.
- Install the tire and wheel assembly. Tighten to specification. See TORQUE SPECIFICATIONS . Lower the vehicle.