LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Envoy RWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instructions >> Trim Panel Replacement - Knee Bolster >> Installation Procedure

Installation Procedure

  1. Position the trim panel to the IP.
  2. Seat the clips that retain the trim panel to the IP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the 4 trim panel retaining screws.

    Tighten 

    Tighten the screws to 2.5 N.m (22 lb in).

  4. Install the left closeout/insulator panel. Refer to CLOSEOUT/INSULATOR PANEL REPLACEMENT - LEFT   . 
    Fig 1: Installing Trim Panel & Screws To Instrument Panel (Knee Bolster)
    G01640870Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals