LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Envoy RWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instructions >> Console Replacement >> Removal Procedure

Removal Procedure

  1. Block the wheels to prevent the vehicle from moving.
  2. Remove the rubber ash tray inserts and rubber mat from the console.
  3. Remove the floor shift control knob.
  4. Remove the center console shift lever bezel, Oldsmobile only. Refer to CONSOLE SHIFT LEVER BEZEL REPLACEMENT (OLDSMOBILE)   . 
  5. Remove the console storage compartment. Refer to CONSOLE STORAGE BIN REPLACEMENT   . 
  6. Remove the center console retaining screws.
  7. Adjust the parking brake to the full-up, or fully engaged position.
    Fig 1: Removing Center Console From Vehicle
    G01640937Courtesy of GENERAL MOTORS CORP.
  8. Release the 2 forward trim extensions ears attached to the lower IP- Oldsmobile only.
  9. Slide the console rearward and raise the rear of the console in order to expose the electrical connectors.
  10. Disconnect the electrical connectors as necessary.
  11. Adjust the parking brake to approximately the halfway position.
  12. Remove the center console from the vehicle.
scientia non olet · About LEMON Manuals