LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Envoy RWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instructions >> Console Replacement >> Installation Procedure

Installation Procedure

  1. Position the center console to the vehicle.
  2. Adjust the parking brake to the full-up, or fully engaged position.
  3. Connect the electrical connectors as necessary.
  4. Lower the rear of the console and slide the console forward into position.
  5. Ensure that the 2 retaining ears on the front extensions of the console are fully engaged to the lower IP-Oldsmobile only.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  6. Install the center console retaining screws.

    Tighten 

    Tighten the screws to 2.5 N.m (22 lb in).

    7. Fig 1: Installing Center Console To Vehicle
    G01640938Courtesy of GENERAL MOTORS CORP.
  7. Install the console storage compartment. Refer to CONSOLE STORAGE BIN REPLACEMENT   . 
  8. Install the center console shift lever bezel. Refer to CONSOLE SHIFT LEVER BEZEL REPLACEMENT (OLDSMOBILE)   . 
  9. Install the floor shift control knob.
  10. Install the rubber ash tray inserts and rubber mat to the console.
  11. Remove the bocks from the vehicle.
scientia non olet · About LEMON Manuals