Brake Pedal Assembly: Installation
- If the brake pedal pivot bushing is damaged or worn, replace the bushing using the following procedure:
- Squeeze the end that will be facing the brake pedal pivot nut.
- Insert the bushing into the pivot hub just enough to hold the bushing in place.
- Push the bushing through the hub until the bushing snaps in place.
- Install the brake pedal.
- Install the NEW brake pedal pivot bolt and the brake pedal pivot nut. Tighten the brake pedal pivot bolt. See TORQUE SPECIFICATIONS .
- Install the stoplight switch to the brake pedal. See STOPLIGHT SWITCH under REMOVAL & INSTALLATION.
- Install the closeout/insulator panel.
NOTE:
The brake pedal pivot bolt is a prevailing torque bolt and must be replaced each time the bolt is removed.