LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Envoy 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instructions >> Trim Pad Replacement - Instrument Panel (I/P) Upper >> Removal Procedure

Removal Procedure

  1. Remove the windshield pillar garnish moldings.

    Refer to GARNISH MOLDING REPLACEMENT - WINDSHIELD PILLAR  in Interior Trim.

  2. Starting at the outboard edges, release the trim pad retaining clips.
    Fig 1: Removing Upper Trim Pad Retaining Clips
    G01640885Courtesy of GENERAL MOTORS CORP.
  3. Rotate the ambient light sensor counter-clockwise 1/4 turn in order to release the sensor from the trim pad.
  4. Remove the trim pad from the vehicle.
    IMPORTANT: Cover the windshield defrost vents with clean shop rags.
  5. Disconnect the electrical connector from the ambient light sensor and retain the sensor for installation.
    Fig 2: Removing Ambient Light Sensor From Trim Pad
    G01640886Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals