LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Envoy 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instructions >> Knee Bolster Replacement >> Installation Procedure

Installation Procedure

  1. Install the knee bolster to the steering column support bracket.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the 4 knee bolster retaining nuts.

    Tighten 

    Tighten the nuts to 10 N.m (88 lb in).

  3. Install the knee bolster trim panel. Refer to TRIM PANEL REPLACEMENT - KNEE BOLSTER   . 
  4. Install the left closeout/insulator panel. Refer to CLOSEOUT/INSULATOR PANEL REPLACEMENT - LEFT   . 
    Fig 1: Installing Knee Bolster To Steering Column Support Bracket
    G01640872Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals