Test Description

The numbers below refer to the step numbers on the diagnostic table.

1. 3.  This step tests the sensor circuitry in the high voltage range.
2. 4.  This step tests the sensor circuitry in the low voltage range. If the fuse in the jumper opens when you perform this test, the signal circuit is shorted to voltage.
3. 5.  This step tests the 5-volt reference circuit of the yaw rate sensor/lateral accelerometer.

Fig 1: DTC C0213-C0216 (1 Of 2)

Courtesy of GENERAL MOTORS CORP.

Fig 2: DTC C0213-C0216 (2 Of 2)

Courtesy of GENERAL MOTORS CORP.