Passenger Door Unlock Operation (Uplevel Vehicles)

When any of the door lock switches are placed in the unlock position, voltage is applied to the door unlock control circuit and the unlock relay winding and the BCM. Since the other side of the unlock relay winding is connected to ground, the relay is energized. This causes the contacts to close and complete the path from the DR LOCK fuse through the battery voltage circuit. Voltage is then applied through the UNLOCK fuse to the unlock side of the door lock actuators. Since the other side of the door lock actuators are connected to the normally closed contacts of the lock relay to ground, the doors unlock.

The unlock function can also be accomplished by the BCM supplying voltage to the door lock control circuit during any of the following:

• A keyless entry unlock transmission
• An automatic door unlock function (if programmed)