LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Yukon Denali >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim >> Repair Instructions >> Molding Replacement - Rear Door Body Side >> Removal Procedure

Removal Procedure

    Fig 1: Rear Door Body Side Molding
    GM741426Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: When any molding is removed, all retaining clips needs to be replaced with new ones if the molding is to be reused.
  1. Remove all retaining screws.
  2. Grasp the lower part of the molding.
  3. Pull outwards to release the clips from the body panel.
scientia non olet · About LEMON Manuals