LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Yukon Denali >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim >> Repair Instructions >> Molding Replacement - Rear Body Side - Lower Front (Avalanche) >> Removal Procedure

Removal Procedure

    Fig 1: Rear Body Side Lower Front Molding (Avalanche)
    GM741427Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: When any molding is removed, all retaining clips must be replaced if the molding is to be reused.
  1. Remove all retaining screws.
  2. Grasp the lower part of the molding.
  3. Pull outward in order to release the clips from the body panel.
scientia non olet · About LEMON Manuals