LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Yukon Denali >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim >> Repair Instructions >> Emblem/Nameplate Replacement - Door (W/O SS) >> Removal Procedure

Removal Procedure

    IMPORTANT: Use the tape for protection and alignment marks for alignment of the new emblem.
  1. Apply tape to the area around the door emblem.
  2. Heat the emblem/nameplate, using a heat gun J 25070  152 mm (6.0 in) from the surface.
  3. Apply the heat using a circular motion for about 30 seconds.
    4. NOTE: Refer to EXTERIOR TRIM EMBLEM REMOVAL NOTICE .
  4. Remove the emblem/nameplate from the door surface using a plastic, flat-bladed tool.
    5. Fig 1: Removing Door Emblem/Nameplate (W/O SS)
    GM348525Courtesy of GENERAL MOTORS CORP.
  5. Remove all adhesive from the door panel surface and the back of the emblem/nameplate using 3M™ scotch brite molding adhesive remover disk 3M™ P/N 07501 or equivalent.
  6. Clean the door surface using varnish makers and painters (VMP) naptha.
scientia non olet · About LEMON Manuals