LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Yukon Denali >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Bumper System >> Repair Instructions >> Fascia Replacement - Rear Bumper (Utility) >> Installation Procedure

Installation Procedure

  1. Align the locator pin of the fascia to the hole in the impact bar.
    2. Fig 1: Installing Rear Bumper Fascia (Utility)
    GM316187Courtesy of GENERAL MOTORS CORP.
  2. Press the push-pin retainers into the underside of the fascia.
  3. Install the Spare Tire Wheel Hoist Guide Retaining Clips. Refer to TIRE HOIST AND SHAFT REPLACEMENT .
  4. Remove the safety stands, and lower the vehicle.
  5. Connect the license plate lamp harness.
  6. Install the top fascia retainers.
scientia non olet · About LEMON Manuals