LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Yukon Denali >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Bumper System >> Repair Instructions >> Bracket Replacement - Front Bumper (1500)

Bracket Replacement - Front Bumper (1500)

    Fig 1: Removing Front Bumper Bracket (1500)
    GM671616Courtesy of GENERAL MOTORS CORP.
  1. Remove all related panels and components.
  2. Remove damaged bumper bracket.
    3. IMPORTANT: Do not remove any material from end of frame rail.
  3. Position the service template on the end of the frame rail. Use 3M's Repositionable Adhesive or equivalent.
  4. Drill three 13 mm (1/2 in) holes at locations indicated on template.
    5. IMPORTANT: Prior to refinishing, refer to the Publication GM 4901M-D-2000 "GM Approved Refinish Materials" for recommended products. Do not combine paint systems. Refer to paint manufacturer's recommendations.
  5. Apply approved anti-corrosion primer to bare metal surfaces.
  6. Position replacement bumper bracket.
    7. NOTE: Refer to FASTENER NOTICE .
  7. Install the bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

scientia non olet · About LEMON Manuals