LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Yukon Denali >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Body Rear End >> Repair Instructions >> Wiring Harness Replacement - Liftgate >> Removal Procedure

Removal Procedure

  1. Remove the liftgate trim panel. Refer to Trim Panel Replacement - Liftgate .
    2. Fig 1: Removing Liftgate Wiring Harness
    GM577905Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the window defogger wiring connectors.
  3. Disconnect the key switch connector.
  4. Disconnect the window ajar switch connector.
  5. Disconnect the wiper module connector.
  6. Disconnect the door lock actuator connector.
  7. Disconnect the door ajar switch connector(s).
  8. Remove the wiring harness clips.
  9. Pull back the rubber boot on door side grommet to expose plastic snap ring
  10. Release the snap ring locks.
  11. Remove the wiring harness from door.
scientia non olet · About LEMON Manuals