LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Yukon Denali >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Body Rear End >> Repair Instructions >> Spoiler Replacement - Rear >> Removal Procedure

Removal Procedure

    IMPORTANT: Be careful not to scratch or chip the paint.
    Fig 1: Rear Spoiler
    GM827106Courtesy of GENERAL MOTORS CORP.
  1. Heat the spoiler using a heat gun. Hold the heat gun approximately 152 mm (6 in) from the surface.

    Apply heat using a circular motion for about 30 seconds.

  2. Starting from one end of the spoiler, peel off the Endgate surface using a flat-bladed tool.
  3. Remove all adhesive from the body panel using a 3M™ stripe off wheel # 07498 or equivalent.
scientia non olet · About LEMON Manuals