LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Yukon Denali >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Body Rear End >> Repair Instructions >> Door Replacement - Rear >> Installation Procedure

Installation Procedure

  1. Install the upper and lower hinge pin retainer clips to the hinge.
    2. Fig 1: Installing Roller Assembly Bolts To Upper Door Side Hinge
    GM572299Courtesy of GENERAL MOTORS CORP.
  2. Install the bolts on the roller assembly to the upper door side hinge.
    3. Fig 2: Installing Rear Door
    GM572307Courtesy of GENERAL MOTORS CORP.
  3. With an assistant, position the door to the vehicle.
  4. Install a bolt through the lower hinge pin holes.
  5. Using a soft-faced hammer and a pair of locking pliers, install the upper hinge pin with the pointed end of the pin pointing upward.
  6. Remove the temporary bolt from the lower hinge.
  7. Install the lower hinge pin with the pointed end of the pin pointing downward.
  8. Remove the cloth-backed tape from the door and the body pillar.
  9. Install the taillamps. Refer to TAIL/TURN SIGNAL LAMP REPLACEMENT .
  10. Install the check assembly hinge pin with the pointed end of the pin pointing downward.
  11. Connect the negative battery cable, as necessary on vehicles with power components. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE (SINGLE BATTERY) or BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE (AUXILIARY BATTERY) .
scientia non olet · About LEMON Manuals