LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Yukon Denali >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel & Steering Column >> Repair Instructions >> Steering Column Trim Covers Replacement - On Vehicle >> Removal Procedure

Removal Procedure

    CAUTION: Refer to SIR CAUTION in Cautions and Notices.
  1. Disable the SIR system. Refer to DISABLING SYSTEM in SIR.
  2. Remove the steering wheel. Refer to Steering Wheel Replacement .
  3. Remove the tilt lever from steering column. Refer to Tilt Lever Replacement - On Vehicle .
    4. IMPORTANT: You must check for 2 pan head tapping screws (1) in the lower trim before removal.
    Fig 1: Lower Trim & Pan Head Tapping Screws
    GM415298Courtesy of GENERAL MOTORS CORP.
  4. If necessary remove the pan head tapping screws (1) that retain the lower steering column trim cover to the steering column.
  5. If no screws are present, gently unsnap the lower trim cover from the upper trim cover.
    6. Fig 2: View Of Lower And Upper Steering Column Covers
    GM328807Courtesy of GENERAL MOTORS CORP.
  6. Tilt the trim cover down and slide it back in order to disengage the locking tabs.
  7. Remove the lower steering column trim cover.
  8. Slide the shift lever seal up the shift lever.
    9. IMPORTANT: You must check for 1 TORX head screw (1) in the upper trim cover (2) before removal.
    Fig 3: Upper Trim Cover & Screws
    GM415299Courtesy of GENERAL MOTORS CORP.
  9. If necessary, remove the screw (1) that retains the upper steering column trim cover to the steering column.
  10. If no screw is present, gently unsnap the upper steering column trim cover.
  11. Remove the upper steering column trim cover.
scientia non olet · About LEMON Manuals