LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Yukon Denali >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel & Steering Column >> Repair Instructions >> Shift Lever Replacement - On Vehicle (Without Tow/Haul Switch) >> Installation Procedure

Installation Procedure

    Fig 1: Locating Seal On The Shift Lever And TORX Head Shift Lever Screw (With Tow/Haul Switch)
    GM362445Courtesy of GENERAL MOTORS CORP.
  1. Install the shift lever (1).
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the TORX® head screw (2).

    Tighten:  Tighten the screw to 1.5 N.m (13 lb in).

  3. Roll the seal over the TORX® head screw (2).
scientia non olet · About LEMON Manuals