LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Yukon Denali >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel & Steering Column >> Repair Instructions >> Intermediate Steering Shaft Replacement - Lower >> Removal Procedure

Removal Procedure

CAUTION: Refer to SIR CAUTION in Cautions and Notices.
NOTE: The wheels of the vehicle must be straight ahead and the steering column in the LOCK position before disconnecting the steering column or intermediate shaft from the steering gear. Failure to do so will cause the SIR coil assembly to become uncentered, which may cause damage to the coil assembly.
  1. Set the front wheels in the straight-ahead position.
    2. Fig 1: Identifying J 42640
    GM333146Courtesy of GENERAL MOTORS CORP.
  2. Install the J 42640  in the steering column lower access hole.
  3. Mark the relationship of the intermediate shaft components in order to assure proper installation.
    1. Mark the relationship of the upper intermediate shaft to the lower intermediate shaft.
    2. Mark the relationship of the lower shaft coupler to the steering gear input shaft.
    4. Fig 2: Lower Shaft Couplet & Bolt
    GM389603Courtesy of GENERAL MOTORS CORP.
  4. Remove the bolt from the upper to lower shaft connection.
  5. Remove the bolt from the lower shaft coupler.
  6. Remove the intermediate shaft assembly.

    Slide the shaft towards the dash in order to get the lower shaft coupler clear of the steering gear input shaft.

  7. Slide the intermediate shaft down out of the upper shaft.
scientia non olet · About LEMON Manuals