Removal Procedure
- Remove the seat trim panel. Refer to Trim Panel Replacement - Front Seat .
Courtesy of GENERAL MOTORS CORP.
- Remove the outboard seat belt anchor nut. Pull the belt through the seat cushion.
Courtesy of GENERAL MOTORS CORP.
- Remove the front nuts (2) on the underside of the seat cushion.
Courtesy of GENERAL MOTORS CORP.
- Unsnap the lumbar cable (6) (disconnect the lumbar wire harness if equipped with power lumbar).
- Disconnect the electrical connectors.
Courtesy of GENERAL MOTORS CORP.
- Lift the seat cushion up off the rear plastic holders (1) on the underside of the seat cushion, and pull forward.
- Remove the seat switch bezel. Refer to Seat Switch Bezel Replacement .
Courtesy of GENERAL MOTORS CORP.
- Remove the lumbar actuator (5).
Courtesy of GENERAL MOTORS CORP.
- Unclip the seat trim cover from the seat cushion frame.
Courtesy of GENERAL MOTORS CORP.
- Using a side motion, carefully separate the seat cushion trim cover from the seat cushion pad.
- Remove the pad from the seat cushion frame.
- Remove the seat cushion heater element, if equipped. Refer to Seat Cushion Heater Element Replacement - Front .