LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Yukon Denali >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Power Seat System >> Repair Instructions >> Seat Cushion Cover and Pad Replacement - Rear (Bench) >> Installation Procedure

Installation Procedure

  1. Install the seat cushion cover and pad to the seat frame.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the bolts (1) on the roller assembly (2).

    Tighten:  Tighten the bolts to 53 N.m (39 lbs ft)

    Fig 1: Installing Bolts On Roller Assembly
    GM841650Courtesy of GENERAL MOTORS CORP.
    3. Fig 2: Installing Support Rod
    GM841644Courtesy of GENERAL MOTORS CORP.
  3. Install the support rod (1) to the bottom of the seat.
    4. Fig 3: Installing Bolts To Grab Handle
    GM841638Courtesy of GENERAL MOTORS CORP.
  4. Install the bolts (2) to the grab handle (1).

    Tighten:  Tighten the bolts to 30 N.m (22 lbs ft)

  5. Install the J-Clips on the back of the seat.
  6. Install the rear seat to the vehicle. Refer to Seat Replacement - Rear Bench .
scientia non olet · About LEMON Manuals