Power Seat Does Not Recline (w/o Memory)

Step	Action	Yes	No
Schematic Reference: Power Seats Schematics IMPORTANT: This table assumes that all mechanical linkage and drivers are free from obstruction and not binding.
1	Did you review the Power Seats System Description and Operation and perform the necessary inspections?	Go to Step 2	Go to Symptoms - Seats
2	Operate the power seat in all directions. Does the system operate normally?	Go to TESTING FOR INTERMITTENT AND POOR CONNECTIONS	Go to Step 3
3	Disconnect the recline motor connector. Connect a test lamp between the recline motor control circuit terminals in the harness connector. Operate the recline adjuster switch in both directions. Does the test lamp illuminate when the switch is activated in both directions?	Go to Step 6	Go to Step 4
4	Test the recline motor control circuits for a open or short to ground. Refer to CIRCUIT TESTING and WIRING REPAIRS . Did you find and correct the condition?	Go to Step 9	Go to Step 5
5	Inspect for poor connections at the harness connector of the power seat switch. Refer to TESTING FOR INTERMITTENT AND POOR CONNECTIONS and to CONNECTOR REPAIRS . Did you find and correct the condition?	Go to Step 9	Go to Step 8
6	Inspect for poor connections at the harness connector of the recline motor. Refer to TESTING FOR INTERMITTENT AND POOR CONNECTIONS and to CONNECTOR REPAIRS . Did you find and correct the condition?	Go to Step 9	Go to Step 7
7	Replace the recline adjuster motor. Refer to Seat Adjuster Motor Replacement - Front . Did you complete the replacement?	Go to Step 9	-
8	Replace the power seat switch. Refer to Seat Switch Replacement - Power . Did you complete the replacement?	Go to Step 9	-
9	Operate the system to verify the repair. Did you correct the condition?	System OK	Go to Step 2