LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Yukon Denali >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Instrument Panel, Gauges & Console >> Repair Instructions >> IP Harness Replacement >> Removal Procedure

Removal Procedure

  1. Disconnect the SDM module. Refer to AIR BAG MODULES .
  2. Remove the door sill plate. Refer to DOOR SILL PLATE REPLACEMENT - FRONT or DOOR SILL PLATE REPLACEMENT - REAR .
  3. Remove the instrument panel. Refer to IP Carrier Replacement .
  4. Remove the HVAC duct. Refer to Air Distributor Duct Replacement .
  5. Disconnect the electrical connectors.
  6. Disengage the harness mounting clips.
  7. Remove the harness from the vehicle.
    8. Fig 1: Locating IP Harness/Electrical Connectors
    G01697351Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals